AUTOMATIC SYNCHRONISING PANELS

 
The new Automatic Synchronising Panel has been designed to fully control a parallel running generator and replace your existing Engine Mounted Control Panel (although it will also work inconjunction with your EMCP). The panels are fully fitted with engine control, motorised circuit breaker and  busbar system. A full range of breaker sizes are available from 250 Amp to 3200 Amp and busbars up to 7000 Amps braced for 80kA for 1 sec.

 
The controller is used to automatically start and stop the engine, indicating the operational status and fault conditions. Operation of the controller is via pushbuttons (with security locking facility) mounted on the front panel with STOP/RESET, AUTO, MANUAL and START pushbuttons plus full Automatic Synchronising, Automatic Load Sharing.
Synchronising and Load sharing capabilities including :-
  • Synch Check
  • Gov/engine speed control
  • AVR/voltage control
  • Dead bus sensing
  • Digital Synchroscope
  • kW Load share for multiple sets
  • Multi-set load demand operation
Metering and instrumentation is provided on the LCD display including :-
  • Generator Volts L1-N, L2-N, L3-N
  • Generator Volts L1-L2, L2-L3, L3-L1
  • Generator Amps L1, L2, L3
  • Generator Frequency Hz
  • Generat kVA L1, L2, L3, Total
  • Generator kW L1, L2, L3, Total
  • Generator PF L1, L2, L3
  • Generator kVAr L1, L2, L3 Total
  • Generator kWh
  • Generator kVAh
  • Generator kVArh
  • Generator phase sequence
  • Engine Speed RPM
  • Engine Oil Pressure PSI
  • Fuel Level %
  • Engine Temp Deg C
  • Plant Battery Volts
  • Engine Hours Run
  • Other functions include :-
  • Multiple Alarm Channels (inluding most engine and alternator parameters)
  • Speed adjust
  • Volts adjust
  • Emergency Stop Pushbutton (red stayput mushroom head)
* Conditions apply. Terms available on request.
For further information please email to  jim@mertech.co.uk